2 months ago
547
25
Posted On: September 21st 2026, 10:08 pm
This is going to be a very useful addition. Finally finished the 4 degree mount for the 4" 6 Buck Chuck
#togodbetheglory #practitioner_of_the_mechanical_arts #thinkoutsidethebox #instatoolmaker #dontleavewellenoughalone
#togodbetheglory #practitioner_of_the_mechanical_arts #thinkoutsidethebox #instatoolmaker #dontleavewellenoughalone
Comments (25)
9 days agolucaselef
What brand ceramic media did you go with? Im looking to get some for my cabinet.
a month agopmthonolulu2
I think the 5" are the smallest with master jaws. Really wish they made em for the 4"....
a month agoappareil.metrologique
I was thinking about the benefit of using 6inch chuck over 8 and which one to use as an OD and ID but I think that the most usefull thing on the 6inch is the small ID jaws diameter
a month agomxpimp47
Incredible! I need to make a few of these backing plates for mine. I have several chucks now. I have the larger 6 jaw Buck chuck on it currently. Well done as always 🙌
Load More
More posts
