Instagram story viewer> @crazy.custom2> Posts

Ken Brownlee

@crazy.custom2

2.7K

followers

1005

following

POSTS STORIES REELS TAGGED

I don’t mean to brag or show off, get go fuel perks by @crazy.custom2

9

3

3 days ago

It was a convertible kind of day, 83 degrees in October, I’ll take it by @crazy.custom2

16

0

3 days ago

Found this neat piece at @goodguysrodandcustom in Columbus back in July, I used it for the power wires from the terminator unit to the battery, worked perfect by @crazy.custom2

17

0

12 days ago

Trying to get it done before the bad weather hits, would like to drive it on the Powertour 2027 but it needs to be bulletproof, new motor (approx 550hp), new T56 trans, Holley Terminator X, oil cooler ,all new clutch, slave cylinder etc taken in Cleveland, Ohio by @crazy.custom2

51

4

15 days ago

Got my grill back on and started running the terminator wiring for my new motor, found this slick bulkhead pass through on Amazon that was perfect 👌, finally getting some hours in on it by @crazy.custom2

31

3

16 days ago

Replaced the clutch pedal on my C10 today with this unit that gives the perfect rod angle and puts everything under the dash, had a clutch pushrod problem before, this eliminates the problem, trying to bulletproof it so it can be driven far with minimal problems, very easy to install, got this from @americanpowertrain #savethestick by @crazy.custom2

31

1

18 days ago

Finally got to do some work on Rusty Gold, had to reposition the oil cooler because it was in the way , screw on the radiator support panels and got the radiator mounted in , nice way to kickstart the truck again by @crazy.custom2

20

0

20 days ago

Exhaust sounding crazy, first gear is super short , volume up by @crazy.custom2

59

4

24 days ago

Corvettes at Carlisle and the 5hour ride home taken in Blue Mountain Travel Plaza by @crazy.custom2

22

0

2 months ago

Corvettes at Carlisle, I didn’t walk around and take a lot of pictures, but a few caught my eye for different reasons, a nice amount of ZR1’s where present by @crazy.custom2

24

1

2 months ago

Went to Carlisle over the weekend and @unitedrestyling surprised us with custom steering wheels for our C8 designed specifically to match our interiors , so my brother and I had to get them, he even had them installed, now I have to keep my hands clean taken in Corvettes at Carlisle by @crazy.custom2

63

3

2 months ago

Oh you can raise or lower your Corvette in like 15 minutes and it won’t cost a dime, 4 days and 140.00 later, they forgot to mention that most bolts don’t turn easily and are most likely frozen , especially on a 19 year old car , couldn’t turn the bolts on the car (10mm) wrench used, had to remove the leaf spring and got one loose and of course the head snapped off the other one, eBay to the rescue, now I’m at two fingers instead of one by @crazy.custom2

54

10

2 months ago