Instagram story viewer> @dayberry_blueprinting> Posts

Jason Dayberry

@dayberry_blueprinting

1.5K

followers

328

following

🔥 Laminar30 Exhaust Technology
⚙️ Engineered V8 Acoustics
🏁 12A/13B Rotary Performance
NOT ASSEMBLED. ENGINEERED.
👇 Shop Laminar30s

POSTS STORIES REELS TAGGED

#rx7 #rx7fc #rx7sa #rx7community #rebuild #rx713brew #rx7club #rx7nation #rx7mazda #rotary #rotarypower #rx7fb

Holley 600 cfm on this ported 12a with tons of modifications to get her dialed in taken in Kent, Washington by @dayberry_blueprinting

693

1

4 years ago

#rx7community #rx7club #rx7nation #rx7mazda #rotary #rx4 #rx4sedan #freshbuild #13b #13bna #13bmazda #13brotary taken in Kent, Washington by @dayberry_blueprinting

964

6

4 years ago

by @dayberry_blueprinting

319

1

4 years ago

⚡ When you’re driving a Tesla and decide to give it a little throttle blip…

Everything is quiet, smooth, and civilized. Instant electric torque, zero exhaust note, zero drama.

But my brain is still programmed for a cammed 5.3L V8 with long-tube headers, Flowmasters, and custom Laminar30 exhaust pulse chambers. 😂🔥

Sometimes you just need to hear eight cylinders come alive.

Electric torque is impressive. But nothing replaces the sound of a naturally aspirated V8! 🏁🔊

Turn the volume up for this one! 😂

#Tesla #V8 #CarReels #TruckLife #CarCommunity by @dayberry_blueprinting

8

2

7 days ago

🔥 Morning wake-up call. Cold air, violent throttle blips, and a V8 screaming to 6,200 RPM.

Wide-open throttle? Absolute chaos. 😈🔥
Lift off the gas? Clean, controlled silence.

No obnoxious rasp. No sloppy decel. Just raw V8 aggression with a sound of its own.

DAYBERRY LAMINAR30
NOT ASSEMBLED. ENGINEERED. ⚙️

#GMC #V8 #TruckLife #ExhaustSound #CammedTrucks by @dayberry_blueprinting

137

9

10 days ago

From aggressive V8 acceleration to razor-sharp throttle blips! 🔥🏁

Listen to the RPMs climb, the exhaust come alive, and the sound disappear almost instantly on deceleration.

A whole different kind of V8 sound. Engineered for a unique acoustic experience. 🔊

DAYBERRY BLUEPRINTING
NOT ASSEMBLED. ENGINEERED. 🔧

#TrucksOfInstagram #PNWTrucks #TruckLife #SilveradoNation #TruckNation by @dayberry_blueprinting

85

2

6 days ago

Hear the cam chop. Hear the WOT scream. Then hear the blinker. 🔊🔥

This cammed 5.3 GMC Sierra goes from wide-open throttle to quiet cabin cruising—almost like stepping inside a library. 📚 You can hear the blinker and heater.

Laminar30 exhaust with APCS — Acoustic Pulse Control System by Dayberry Blueprinting. Turn it up and hear the contrast.

#Trucks #TruckLife #TrucksOfInstagram #V8 #cammed by @dayberry_blueprinting

93

0

8 days ago

1,200 RPM → 6,000 RPM almost instantly. 👀

This is what the Laminar30 development process looks like.

RPM sweep.
Higher gear pulls.
Stainless fabrication.
Under-truck installation.
Then pull over and listen to that cam chop.

The higher the gear, the harder this thing just keeps pulling through the RPM.

This isn’t a muffler.
It’s not a resonator.
It’s a Laminar.

DAYBERRY BLUEPRINTING
NOT ASSEMBLED. ENGINEERED.#Laminar30 #DayberryBlueprinting #GMCSierra #Silverado #GenV LTPerformance 53L CammedTruck ExhaustFabrication TIGWelding StainlessExhaust CustomExhaust TruckBuild Performance by @dayberry_blueprinting

120

0

17 days ago

From fighter-jet howl to stealth-mode cruise, then the cam reminds everybody it’s still a 5.3 😈✈️

Laminar30 APCS
3” in / 3” out
Open-flow design
No chambers. No packed core. No traditional muffler sound.

NOT ASSEMBLED. ENGINEERED.#Trucks #PNWTrucks #TruckLife #ModifiedTrucks #TruckBuild by @dayberry_blueprinting

17

0

20 days ago

#Laminar30
#DayberryBlueprinting
#CustomExhaust
#ExhaustEngineering
#LSPerformance by @dayberry_blueprinting

456

18

a month ago

Resonator or muffler? GMC Sierra 5.3 exhaust sound - WOT pull, cold start Which setup sounds better?

Sound on - full setup in comments 👇

#gmcsierra #silverado #flowmaster #truckexhaust #exhaustsound by @dayberry_blueprinting

180

4

a month ago

CAMMED GMC SIERRA 5.3 EXHAUST COMPARISON 🔊
WE GOT DATA! 📊

BTR Stage 2 cam, VVT retained, long-tube headers and three different exhaust configurations tested back-to-back from WOT through the 6,200 RPM shifts and into decel.

1. Laminar30 + Flowmaster Super 10s + axle-back
2. Laminar30 + axle-back • no Flowmasters
3. Flowmaster Super 10s + axle-back • no Laminar30s

This time we’re not just saying what sounds better. We got data.

The spectrogram shows how each setup carries exhaust energy through the RPM range, what happens during each 6,200 RPM shift, and how quickly the system settles after throttle lift.

The Laminar30 setups aren’t simply changing volume. You can actually see the differences in frequency structure, harmonic behavior, and decay.

2018 GMC Sierra 5.3L • Gen V L83 • BTR Stage 2 Cam • VVT Retained • Long-Tube Headers • Dual 3” Exhaust

#GMCSierra #flowmaster #btrstage2 v8engine exhaustsound by @dayberry_blueprinting

76

2

a month ago