Instagram story viewer> @tre_audio> Posts

tre_audio | Guitar Amplifiers & Pedals

@tre_audio

2.1K

followers

377

following

🎸 Guitar Amps and Pedals
📍 Charlottesville, VA, USA
👇 Shop

POSTS STORIES REELS TAGGED

This Buffered Splitter Quad pedal has been selling out faster than we can keep up with lately. I guess everyone likes to keep their tone pristine and strong.

We have an email list where we let folks know about restocks. Check it out, meow. by @tre_audio

8

0

23 days ago

ETID at the Canal Club in 2017. The place went crazy. The crowd surged onto the stage and Andy got piled on, but never missed a riff.

Forever @andycomplains by @tre_audio

57

2

a month ago

Still thinking about these shots of our amps and pedals taken at @goldenponyva Support local artists, builders, and venues! by @tre_audio

26

1

2 months ago

Devil’s Claw Pre-Amp pedal. This is the same circuit that we use in the big boy 300 W Devil’s Claw guitar amp.

Press MUTE to kill your guitar signal…..or the bass player’s signal. 😳

Simple op-amp boost to give your guitar a kick.

FS-1 Channel Switch. Made for the Wretched Beast.

clicky clicky

Two channels. Tons of tone. by @tre_audio

12

0

2 months ago

Delay Pedal adds echo from 60 ms to 1.5s of delay time to your guitar or synth. This can take your signal from a rapid spring-like echo to long canyon-like echo. By cranking the Repeats knob, the Delay will go on seemingly forever.

The pedal features controls for the number of Repeats, the length of Delay, and the amount of Mix of the original guitar signal with the delayed signal. A true-bypass footswitch helps to keep your tone pure when the pedal is not in use. by @tre_audio

12

1

3 months ago

We built a dedicated 10mm Green/Red status LED directly into the Devil’s Claw 300W solid-state guitar amp.

Solid Green: Everything is nominal, voltages are stable, and you are 100% ready to rock.

Red Alarm: If any of the three thermal sensors (or other critical faults) are triggered, the light instantly switches to Red, indicating the amp has entered protection mode to save its circuitry.

Once the amp cools back down to safe operational limits, the protection circuit automatically resets, the LED pops back to Green, and you’re ready to play. No fried transformers, no blown output sections, and no permanent component failure. Just built-in peace of mind for the hottest months of the year. by @tre_audio

41

1

3 months ago

Do you fly rig? by @tre_audio

14

0

3 months ago

The tre_audio Fuzz pedal.

We took a classic transistor architecture and maxed out the clipping amplifier circuit for intense, saturated harmonic sustain. No fluff, just heavy silicon dirt that stays articulate. taken in Charlottesville, Virginia by @tre_audio

21

6

3 months ago

Devil’s Claw 300W solid-state guitar amp. by @tre_audio

29

1

4 months ago

How do you use your Buffered Splitter? by @tre_audio

46

3

4 months ago

We had a blast at the Punk Market at the Golden Pony. The stage there made an awesome backdrop for our gear, just like it’s done for countless bands over the years.

#guitargear #goldenpony #ampsonstage by @tre_audio

36

8

5 months ago

Come check out our guitar amps and pedals at the Punk Market at the Golden Pony in Harrisonburg, VA on Saturday May 9th.

We only have a few units remaining of some items so get there early.

#punkmarket #goldenpony #guitaramps #maker taken in The Golden Pony - VA by @tre_audio

25

1

5 months ago