Instagram story viewer> @amanatool> Posts

Amana Tool

@amanatool

32.3K

followers

134

following

POSTS STORIES REELS TAGGED

Download All

Cutting tenons with an @amanatool radial arm saw blade from @toolstoday on the @kingcanadatool radial arm saw by @amanatool

5k

44

5 months ago

A behind the scenes look at how Amana Tool bits are made, this was such an incredible process to see in person! Starting from raw carbide, through precision grinding, inspection for accuracy, Spektra coating, and finally packaging. A full look at the process that turns raw material into a finished cutting tool, end to end. Check out the Amana Tool coated bits available from @toolstoday! by @amanatool

565

15

8 months ago

From bare carbide to Spektra coated in seconds! A behind the scenes look at how Amana Tool bits get their Spektra™ coating. Load the uncoated tools, close the door, and open it back up to something that feels like magic. It’s not something you get to see every day and the results speak for themselves. Check out the Amana Tool Spektra™ coated bits available from @toolstoday! by @amanatool

927

34

8 months ago

This @amanatool carbide insert spiral shaper cutter from @toolstoday is a very handy cutter to have for a wide range of tasks by @amanatool

4k

61

10 months ago

Getting all the @amanatool router bits and pre drill bits organized. When it comes to router bits if Amana doesn’t have it. It probably doesn’t exist @amana_tool_europe by @amanatool

2k

47

a year ago

Testing an @amanatool round nose bit for some fluting I might do on the conference table @amana_tool_europe by @amanatool

2k

16

a year ago

This is the clean cutting @amanatool tongue and groove 3 wing shaper cutter set in the @kingcanadatool shaper. @amana_tool_europe by @amanatool

3k

30

a year ago

This big 16” @amanatool blade slicing through these 2.5” Bastogne walnut slabs like butter. These are the slabs I picked up at @blackforestwoodco a few months ago and it’s the first time I’ve worked with Bastogne walnut and it’s beautiful wood and it will interesting to see how it looks with a finish on it. by @amanatool

4k

57

a year ago

Putting a round over edge on the butcher block with the @amanatool 4 flute 1/2” carbide tip round over bit @amana_tool_europe by @amanatool

12k

106

a year ago

Using the 3” long @amanatool 1/2” straight plunge bit to finish off and clean up the half lap @amana_tool_europe by @amanatool

4k

37

a year ago

Taking the big @amanatool 45 degree chamfer bit for a test drive in the @kingcanadatool shaper 👍 @amana_tool_europe by @amanatool

5k

97

a year ago

Now to cut the final part of the wedged tenon side of the stair treads using the @amanatool dado set in the @kingcanadatool table saw by @amanatool

6k

180

a year ago